Exploding Fish Heavy-Duty Replacement Rod Holder Inner Tube Sleeve - 10", 0-Degree [2A0010] Marine Hardware | Hatches Extra seam tape on the

Extra seam tape on the welds for added strength

Replacement outboard tilt trim motor that will fit BRP-OMC 1998-Up

Rod Holder Inside Diameter: 1-5/8"This product may not be returned to the original point of purchase

LED Removable Telescopic 360° All Around Lights are approved for USCG 2NM (Colreg 2 mile)

Profile Of Fixture: 3

Exploding Fish Heavy-Duty Replacement Rod Holder Inner Tube Sleeve - 10", 0-Degree [2A0010] Marine Hardware | Hatches Extra seam tape on theHeavy Duty Replacement Rod Holder Inner Tube Sleeve 10", 0 Degree These are the Heavy Duty rod holder Inner Sleeves (FXD ROT) for 30 degree 15 degree 00 degree rotating and fixed rod holders. They are fully engineered and made of a UV resistant rubber compound. Note: It is recommended that a small application of either Sikaflex or Loctite 480 be applied after installation between the rubber and stainless tube down at the gimbal pin height for extra